Fuel filler

 One more post about the fuel filler, just for my own memory to be honest. The fuel filler neck arrived;

And thankfully it was a usable size, this photo compares it to my moulded one. It's maybe a little larger which is fine. The main frustration is that the Ebay listing said it was new, this was far from new. I don't think it's been used, but the chrome is so tarnished that it looks like it's sat in someone's toolbox for years. It's annoying, but not worth trying to get a refund, after all it's still usable.

The only thing was the angled edges that the cap locks on to, they were simply to severe for the cap to lock. This was expected, I knew I'd be out of luck to get them to work perfectly. Fortunately a few minutes with the dremel got me a shallower angle that the fuel cap could lock to. So that's that.

Now comes the fitting. My idea had been to weld a steel collar on to the tube that would sit inside the bodywork. This neck would then protrude above the body, with maybe a decorative trim to finish it off. Problem is this neck is actually wider than the two inch tube, so I'm not going to be able to weld a collar on and get it to fit through the body. I could make the body hole wider for the neck, but then I'd need to trim it. And again, because the neck is wider than the tube, the trim wouldn't work either. 

I think it's an opportunity for some more 3D printing... Basically I want a bracket to sit under the body. The internal diameter will be for the tube. Then I want an upper lip to fill the hole in the body where the neck needs to fit through. Then the overall part should be wide enough to fix the tube to the body.

Or... I can do the same, but have the tube come in from above. That way I can make the hole only big enough for the tube rather than the neck. I could still use a 3D printed collar to bond everything in place. That would mean I wouldn't need an outer trim, I could just make sure the bodywork hole is tight against the tube. The neck itself would then sit just above the body.

Oh, but that introduces a new problem. When I lock the fuel cap, it needs me to press down on the cap. If I do that too often, I might end up pushing the tube through the collar. However that could be mitigated by my gluing approach, if I use two halves of a collar then I can more easily apply epoxy inside the collar. I could then use a jubilee band during gluing to really press it on there. 

I could also reinforce it by using another 3D printed collar underneath the neck lip. It doesn't need to be much, just enough so the neck sits proud and so the cap has about 1mm clearance to the bodywork. I don't want it to sit on the body because that would scratch the body over time, as well as make it difficult to lock as things wear.

Right, that's my notes sorted, I can come back to that another time. My task for this weekend is to get the loom sorted, or at least get the spaghetti sorted. Even if I don't get all the way to the dash, at least I could get the engine ready to run. Two solid days should be enough, as long as I don't make excuses to avoid it. Like writing a blog post on how to fix a fuel cap...