This is going to be my reference for wiring, rather than a blog update. However it may be useful for some.
I've split the wiring into parts, so I'll reference each part below. All pinouts are from looking into the male connector.
Front lights
(For reference, pins 1, 3 and 8 have square corners)
1. Dipped beam right
2. Dipped beam left
3. Side lights
4. Full beam right
5. Full beam left
6. Not connected
7. Right indicator
8. Left indicator
9. Not connected
Rear lights
1. Fuel pump
2. Fuel pump additional
3. Position/Tail (Red/Black)
4. Brake (Green)
5. Reverse (Red/Green)
6. Fog (Green/Yellow)
7. Right indicator (Green/Black)
8. Left indicator (Green/White)
9. Not connected
Black is earth going to two chassis points.
Gauges
1. Illumination positive (red).
2. Temperature gauge signal (blue/black).
3. Common ground to chassis (black).
4. Gauge positive (black/yellow).
5. Oil pressure signal (yellow/red).
6. Rev counter signal (yellow/blue).
Tell tales
1. Side lights. (red)
2. Main beam. (Red/white)
3. Left indicator. (Green/black)
4. Common ground to chassis. (black)
5. Right indicator. (Green/white)
6. Fog light. (Green/yellow)
2. Brake fluid positive. (Black/Yellow)
3. Battery negative. (White/blue)
4. Brake fluid negative. (Blue/yellow)
Toggle Switches
1. Fog. Green Yellow to Fog light
2. Fog. Red black from headlights (So only power with lights on)
3. Hazard. Orange to flasher relay
4. Hazard. Black to earth
No comments:
Post a Comment